7-86 Installing replaceable parts
6. Reverse the procedures in Steps 1 and 3 to restore the
module.
7. Run a datajack test, as described in Chapter 3.
Installing sm art card alert
The smart card alert feature is described in Chapter 1 of this
document.
This procedure describes how to install a smart card alert
daughter board kit into an existing terminal.
1. This procedure assumes you have:
• followed the directions in
Preparing the terminal
for maintenance
and
Opening the terminal,
and
confirmed that the power has been disconnected
• removed the PCP assembly, as described in
Re
moving the PCP assembly
• removed the alerter and keypad two-wire cable
connectors from whichever PCP they are currently
connected to
• removed the control PCP as described in
Remov
ing the telephony and control PCP.
Put the PCP
assembly in an anti-static bag and set it aside
2.
If you are installing the feature for the first time, go to
In
stalling smart card alert firmware.
If you are replacing a daughter board, go directly to
Installing the daughter board.
NTP: 506-6501-203 Document issue: 00.01 Status: Standard Date: January 1997
Summary of Contents for Millennium multi-pay M1211
