NEC SL1100, Features And Specifications Manual

Page: 518 / 864

Program
Number
Program Name Default Note
80-01-01 (48) Service Tone Setup - Repeat Count 0 (endless)
80-01-02 (48) Service Tone Setup - Basic Tone Number 0
Operation
To leave a Message Waiting:
1. Call busy or unanswered extension.
2. Press the Message Waiting key (PRG 15-07 or SC 751 : 38).
3. Hang up.
With Multiline Terminal telephones, the Message Waiting LED lights.
To answer a Message Waiting:
When you have a message, your Message Waiting LED flashes fast for Multiline Terminals.
1. At the Multiline Terminal, press Speaker key and dial * 0 .
- OR-
Press the Message Waiting key (PRG 15-07 or SC 751 : 38).
- OR-
At the Single Line Terminal, lift the handset and dial
*
0 .
If the called extension does not answer, dial 0 or press your Message Waiting key to automatically
leave them a message.
Normally, your Message Waiting LED goes out. If it continues to flash, you have new messages in
your Voice Mail mailbox or a new General Message. See “To check your messages” below.
To answer a Message Waiting (When VM Message Exist):
If there is a VM message and a Message Waiting set on the same extension and the user dials *0, it will
call the VM pilot because VM has a higher priority. To call back the message waiting caller before
calling VM you must do the following:
1. Press the Message Waiting key (PRG 15-07-01 or SC 751 : 38 ).
- OR-
1. Press Help key + dial * 0 .
2. Show the current MW status.
3. Change the status by the Up or Down Cursor key.
4. Press Speaker key.
To cancel all your Messages Waiting:
This includes messages you have left for other extensions and messages other extension have left for you.
1. At the Multiline Terminal, press Speaker key.
- OR-
At the Single Line Terminal, lift the handset.
SL1100 ISSUE 2.0
1-506 Message Waiting
M