Operation and Maintenance
579
■
Is the CD/DVD media dirty or scratched?
→
Check if there is no finger print, taint or scratch on the disk surface of the CD/DVD media. If there
is taint, clean the disk surface of the CD/DVD media. If the media still cannot be loaded after the
cleaning, replace another loadable CD/DVD media to check if it can be loaded.
Unable to power off at the blue screen.
→
When turning off the server at the blue screen, keep pressing EPO switch of the management
module on the rear of the server for more than 5 seconds.
Unable to connect to network.
■
Is the cable connected?
→
Check how the network cable is connected. Check also the used cable is compliant with the
network interface standard.
■
Are the setup of the protocol and services completed?
→
Install the dedicated network driver. Check also the protocol setting up of TCP/IP, the
transmitting speed setting and each service are properly set.
Unable to install OS.
■
Is there any data remaining on the disk to install OS?
→
The OS installation may fail if some data is remaining on the created virtual disk. Install the OS
again after executing “
Slow Initialize”
on Web BIOS.
■
Is the disk recognized?
→
Virtual disk needs to be created for the internal disk of the server.
Configure the disk array.
Unable to check hard disk consistency.
■
Is the RAID level of the logical drive RAID0? Or is the RAID level hot spare disk?
→
RAID0 and hot spare disk cannot be checked consistency since there is no redundancy.
Unable to end POST.
■
Is memory properly installed?
→
For
A1080a-S/A1080a-D
model, at least one set of two DIMMs must be installed in the
processor memory module.
For
A1080a-E
model, at least one set of four DIMMs must be installed in the processor memory
module for operation.
Summary of Contents for Express5800/A1080a
