Hardware
485
2.10 Fault Information
Fault Information is displayed by selecting
“Fault Information”
from the left side of the screen.
Fault information of hardware unit is displayed in
Fault Information.
(1) If
“Clear All”
button is clicked, the following process runs.
The following process runs in server web console.
Restore the health status of this server to normal status
Restore the failure status of all resources in this server to normal status
If the resource is disabled with failure, change the resource’s enable/disable status to
enable status.
If the cores are deconfigued(At this time, the core information will not be displayed at
“Core Status”), these cores will be configured to the system as enabled status. (This
functionality is for Non-COPT (Capacity Optimization) Model only.)
(2) Clicking
“Enable/Disable”
enables to move to
Enable/Disable Component
screen.
(1)
(2)
(3)
IMPORTANT:
The status of the resource which a customer engineer changed
is not changed.
If this server is powered on, you can not run this operation
correctly. Please make sure this server is powered off before
run this operation.
If
“Clear All”
button is clicked, the following
message will be displayed. “Faults cleared successfully.”
Summary of Contents for Express5800/A1080a
