NEC ELECTRA ELITE IPK II, Features And Specifications Manual

Page: 333 / 996

Electra Elite IPK II Document Revision 1
Direct Inward System Access (DISA) 2 - 311
25-07-09 System Timers for VRS/DISA - DISA Internal Paging Time
This is the maximum length of an Internal Page placed by a DISA caller. If the Page continues
longer than this interval (0~64800 seconds), the system terminates the DISA call.
25-07-10 System Timers for VRS/DISA - DISA External Paging Time
This is the maximum length of an External Page placed by a DISA caller. If the Page continues
longer than this interval (0~64800 seconds), the system terminates the DISA call.
25-07-13 System Timers for VRS/DISA - VRS/DISA Busy Tone Interval
If a DISA caller dials a busy extension (and Program 25-04 = 0), the system plays busy tone for
this interval before disconnecting.
25-08-01 DISA User ID Setup
For each DISA user, set the 6-digit password.
25-09-01 Class of Service for DISA Users
Assign a DISA Class of Service for each user. The DISA Class of Service cannot be 0. You
cannot use the 20-xx-xx and 42-xx-xx programs to assign Class of Service to DISA trunks (15
users, with one password and DISA Class of Service 1~15 for each user).
25-10-01 Trunk Group Routing for DISA
Use this program to assign the Trunk Group Route chosen when a user places a DISA call into
the system and dials 9. Set Trunk Group Routing in Program 14-06. If the system has ARS,
dialing 9 accesses ARS. The route chosen is based on the DISA Class of Service, which is
determined by the password the caller dials.
Trunk Group Routes: 1~100
25-11-01 DISA Toll Restriction Class
If the system uses Toll Restriction, enter a Toll Restriction Class (1~15) for each DISA user
(1~15). The system uses the Toll Restriction Class you enter in Program 21-05. The Toll
Restriction Class assigned to a DISA call is based on the DISA Class of Service, which is
determined by the password the caller dials. You cannot use Program 21-04 to assign Toll
Restriction to DISA trunks.
25-12-01 Alternate Trunk Group Routing for DISA
Assign the trunk route that DISA Caller’s access if they dial the Alternate Trunk Route Access
Code. Refer to
Central Office Calls, Placing on page 2-171 for more information on setting up
Alternate Trunk Route Access.
The Continue and Disconnect codes are set in 20-28 below and apply to both DISA and Tandem Trunk calls.
Trunk Continue/Disconnect Codes
14-01-25 Basic Trunk Data Setup - Continue/Disconnect Trunk-to-Trunk Conversation
When Program 24-02-10 is set to disconnect a trunk after the defined time, determine whether
or not a user should have the ability to use the continue/disconnect code
0 = Disabled
1 = Enabled