NEC ELECTRA ELITE IPK II, Features And Specifications Manual

Page: 249 / 996

Electra Elite IPK II Document Revision 1
Conference 2 - 227
Required Component(s)
None
Related Features
Not applicable
Programming
10-07-01 Conversation Record Circuits
Determine if there are conference circuits available, that not all have been assigned as
conversation record circuits.
11-12-08 Service Code Setup (for Service Access) - Barge-In
If required, use this program to change the code users dial to Barge-In to a Conference call. This
code is normally 710.
11-12-47 Service Code Setup (for Service Access) - Call Waiting Answer / Split Answer for SLT
If required, use this program to change the code users dial to Split while on a Conference call.
This code is normally 794.
11-12-57 Unsupervised Conference/Tandem Trunking
With two trunks in Conference press the Hold key and dial #8 and the Conference/Tandem
happens.
11-12-58 Service Code Setup (for Service Access) - Transfer Into Conference
If required, change the service code used to transfer a call into a Conference call (default: 624).
11-16-02 Program 11-16 : One-Digit Service Code Setup - Barge-In
If required, use this program to define the single digit service code users dial to Barge-In to a
Conference call.
14-01-04 Basic Trunk Data Setup - Transmit Gain Level for Conference and Transfer Calls
CODEC gain set at 0 dB (14-01-04 = 32) can be used to set the CODEC gain type for multiline
Conference calls.
15-02-24 Multiline Telephone Basic Data Setup, Conference Key Mode
This option allows an extension’s Conf key to be programmed for Conference or for Transfer.
When set for Transfer (1), the user places a call on hold, dials the extension to which it should be
transferred, the presses the Conf key. The call is then transferred. When set for Conference (0),
with an active call, the user presses the Conf key, places a second call, then presses the Conf
key twice. All the calls are then connected.