NEC ELECTRA ELITE IPK II, Features And Specifications Manual

Page: 622 / 996

Document Revision 1 Electra Elite IPK II
2 - 600 Multiple Trunk Types
Programming
Loop Start/Ground Start Trunks
14-04-01 Type of Connection
Indicate if the trunk is installed behind a PBX (1) or not (0). There is one item for each of the
Night Service Modes.
14-05-01 Trunk Group Number / Order Number
Assign trunks to Trunk Groups. You can also assign the outbound priority for trunks within the
group. When users dial up the trunk group, they seize the trunks in the order you specify in the
outbound priority entry.
22-02-01 Incoming Call Trunk Setup
For each Night Service mode, enter service type for each trunk.
81-10-01 DP Interdigit Time Selection
Select the DP Interdigit Time (minimum pause time between Dial Pulses).
81-10-02 Prepause Time Selection
Specify the loop open time for a hookflash signal sent to the CO or PBX when the Recall key on
a Multiline Terminal is pressed. A Single Line Telephone (SLT) generates a hookflash to the CO
or PBX line when a Single Line Telephone hookflash is assigned.
81-10-03 Incoming Signal Detect Time Selection
Specify the time after the incoming signal from another system is detected before the
acknowledge signal is sent out.
81-10-04 Disconnect Recognition Time Selection
Specify the minimum time before a disconnected circuit can be accessed again.
81-10-05 Automatic Release Signal Detection Selection
Specify the signal detection time for release of a CO/PBX line after a disconnect signal is
received from the distant Central Office or PBX.