Mitsubishi QD75M1, User Manual

Page: 678 / 882

15 - 31
MELSEC-Q
15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
Set range
(Setting with sequence program)
Remedy
71 221 371 521 0, 1
72
73 222
223 372
373 522
523
• [mm] [inch] [PLS]
–2147483648 to 2147483647
• [degree] 0 to 35999999
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
74
75 224
225 374
375 524
525 1 to 10000000 [PLS/s]
1 to 2000000000 [mm/min or others]
• Bring the setting into the setting range.
• Set the speed to the bias speed at start or higher.
(Refer to section 5.2.5)
76
77 226
227 376
377 526
527 1 to 10000000 [PLS/s]
1 to 2000000000 [mm/min or others]
• Bring the setting into the setting range.
• Set the speed to that below the OPR speed.
• Set the value to the bias speed at start or higher.
(Refer to section 5.2.5)
78 228 378 528 0, 1
79 229 379 529 0 to 65535
80
81 230
231 380
381 530
531
0 to 2147483647
82 232 382 532 0, 1, 2, 3
83 233 383 533 0, 1, 2, 3
86 236 386 536 1 to 300
88 238 388 538 0, 1
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.