Mitsubishi QD75M1, User Manual

Page: 532 / 882

12 - 3
MELSEC-Q
12 CONTROL SUB FUNCTIONS
Sub function Details
Absolute position system function
This function holds the current value.
This function sets the absolute position coordinate in relation to the OP in the
machine movement range, and prevent the OP from being lost even if the
power supply is turned OFF to ON.
Step function
This function temporarily stops the operation to confirm the positioning
operation during debugging, etc.
The operation can be stopped at each "automatic deceleration" or
"positioning data".
Skip function
This function stops the positioning being executed (decelerates to a stop)
when the skip signal is input, and carries out the next positioning.
M code output function
This function issues a sub work (clamp or drill stop, tool change, etc.)
according to the code No. (0 to 65535) set for each positioning data.
Teaching function
This function stores the address positioned with manual control into the
positioning address ( Da.6 Positioning address/movement amount) having
the designated positioning data No.
Target position change
function This function changes the target position during the execution of positioning.
At the same time, this also can change the speed.
Command in-position
function
At each automatic deceleration, this function calculates the remaining
distance for the QD75 to reach the positioning stop position, and when the
value is less than the set value, sets the "command in-position flag".
When using another sub work before ending the control, use this function as
a trigger for the sub work.
Acceleration/deceleration
process function
This function adjusts the control acceleration/deceleration.
Other functions
Pre-reading start function This function shortens the virtual start time.