METRODATA LTD
WCM1100 / WCM3100 / WCM-Serial / LHM1000 / LVM2000 User Manual
76-02-082 Rev N
79 of 169
5.3.1.7.1.2.2
S-VLAN (Access Port)
The S-VLAN definition defines the ID to be used for tags pushed onto frames ingressing
an access port. This value also defines that frames ingressing a trunk port with this ID will
egress with the S-Tag popped from this port.
5.3.1.7.1.2.3
Priority Source (Access Port)
The priority source is used to determine the source of the priority value in the frames
egress tag. The options are as below:
Default
Use the default port priority for all frames ingressing this
port. This will overwrite any incoming tag PCP bits with
the default value.
C-Tag, Default
For incoming tagged frames, use the priority PCP bits
from the received tag, for untagged frames use the port
default priority.
DSCP, Default
For incoming IP frames use the DSCP priority, with the
translation to determine the PCP value. For non IP use
the default value.
C-Tag, DSCP, Default
For incoming tagged frames, the priority will be taken from
the tag PCP priority. For untagged frames, the DSCP
value will be used, according to the priority translation
setting where available, otherwise the port default priority
setting will be used.
5.3.1.7.1.2.4
Default Priority (Access Port)
The default priority is the priority value to be used for frames ingressing this port, unless
any other source has been specified.
The valid range is 0 (low) to 7 (high)
5.3.1.7.1.3 Control C-VLAN (Access Port)
This setting is not used, please leave as default.
