Message
Description
Appears in
Role does not exist
Role being applied to Use Config
doesn't exist.
User Config
User does not exist
User in User Config doesn't exist.
User Config
Role already exists
While trying to create a new Role, the
Role already exists.
User Config
User already exists
While trying to create a new User, the
User already exists.
User Config
Admin roles cannot be assigned.
User and role cannot be applied
currently under User Config.
User Config
The remote server is unavailable
Cannot connect to remote server at
this time.
Connection screen
Arc Detected
Arc was detected while performing DC
Test.
Automatic and Manual DC Test)
Over Current Detected
Over Current was detected while
performing DC Test.
Automatic and Manual DC Test)
____ is Invalid
User inputed value for field is invalid
and does not fall within range.
Test Config
If primary device is not host, then a
power pack must be selected
User must have host or power pack
selected under test config.
Test Config
AC Power Not Available
AC Power was disconnected.
All tests.
Test Results could not be found for this
asset
No test results were found for the
selected asset.
Executing routes
Failure connecting to external devices
Could not connect to external device
for calibration.
RLC Calibration
Firmware update failed
Firmware could not be updated onto
device.
Tester Config
R unbalance exceeded test limit
Software detected resistance
unbalance test limit failure.
Manual, Automatic, and Sequence
RLC tests
Invalid Hipot Step
User inputed a value that is not valid
for HiPot Step testing.
Test Config
Invalid IR/DA/PI Times
User inputed invalid test times for IR,
DA, or PI tests.
Test Config
PI test must complete last
User attempted to specify a time for
an IR, DA, or PI test where the PI test
would not complete last.
Test Config
If primary device is not host then a
power pack must be selected
User selected a primary device
other than the host in the Test
Configuration.
Test Config
Exceeded defined Target Voltage in
Active Test Config.
User ramped to a target voltage that
exceeded the voltage defined in the
Test Configuration being used.
All DC and Surge tests
Lowering ramp rate can help with this
issue.
Resistance drop limit exceeded
When a resistance drop exceeds
the percentage set in the active Test
Configuration for Max res change and
Stop on fail is checked, this message
appears.
All DC Step HiPot Tests
No active route to close
User tried to close a route that is not
active.
Executing routes
Not all assets tested. Close route?
User tried to close a route without
testing all assets.
Executing routes
www.megger.com
Megger Baker ADX User Guide
143
Error and Failure Messages List
Summary of Contents for ADX15
