Maeda MC815C, Operation Manual, Page: 400 / 426

390
1. CAUTIONS IN USING SEARCHER HOOK
• Be sure to change to the searcher hook mode on the monitor when the searcher hook is
mounted. If you use the machine without changing the mode, damage to or overturn of the
machine might occur causing a serious accident.
• When using a searcher hook, remember to set the engine in an idling mode and work with a
crane in a slow speed. If you operate a lever in a sudden motion, the searcher hook might
break due to the excess force, causing a serious accident.
• If you make an error in a searcher hook operation, the searcher hook might fall due to the
bracket deformation or a crack on the welded section. Remember to check each part of a
searcher hook and make sure there are no deformation or cracks on the welded section.
• When changing the angle of the searcher hook, never put your fingers into the pin hole. It may
cause a serious accident.
• When changing the angle of the searcher hook, change the displayed angle on the monitor
according to the actual angle. If you use the machine without changing the mode, damage to
or overturn of the machine might occur causing a serious accident.
• See “Safety” section for the safety precautions that are not provided in this section.
CAUTION
• Mass of the machine varies depending on the
specification.
The figure on the right shows the weight table for
weight of standard vehicles and the additional weight
of each accessory unit.
• The angle of searcher hook can be switched manually to six different patterns.