Maeda MC815C, Operation Manual, Page: 378 / 426

368
7. Reconnect the hydraulic hoses on the right section of the
main boom tip and on the right section of the fly jib base,
following the procedure below.
(1) Remove the caps from the couplers 3 (F3) and 4 (F4).
(2) Remove the coupler (F2) of the hydraulic hose A (F5)
connected to the main boom side and reconnect it to
the stowage coupler 3 (F3) on the fly jib side.
(3) Remove the coupler 1 (F1) of the hydraulic hose B
(F6) connected to the main boom side and reconnect it
to the coupler 4 (F4) on the fly jib side.
(4) Attach the caps to the couplers 1 (F1) and 2 (F2).
CAUTION
• Be sure to reconnect the hydraulic hose. Otherwise, the
hose might be bent and damaged.
• If the coupler is dirty, attach the coupler after cleaning it.
• The coupler cap should be attached to prevent foreign
objects to be mixed in.
8. Attach the lever block (23) and the wire (13) to the main
boom and the fly jib base (4) to adjust the position using the
lever block (23).
Pull out the shaft lock pins of the position pins (A1, A2) on
the left section of the fly jib mounting bracket (27) and pull
out the position pin A2 first, then A1 from the left section of
the fly jib mounting bracket (27).
NOTES
One of the position pins (A1, A2) is used to fix the fly jib later,
and another is stowed.
9. Remove the wire (13) and the lever block (23) from the
main boom and the fly jib base (4) and mount the lever
block (23) to the No.1 fly jib (2) and the fly jib base (4) so
that the bracket can be stowed easily.
NOTES
The lever block (23) should be attached with a tension so that
the No.1 fly jib (2) is slightly lifted.
FLY JIB STOWED
FLY JIB SET