Kärcher MC 130, Manual

Page: 90 / 414

-
38
ATTENTION
When the battery is charged, first remove the charger from
the mains and then disconnect it from the battery.

DANGER
Risk to life

When carrying out repairs, remove the vehicle from the
danger zone of passing traffic and wear reflective clothing.
몇
WARNING
Risk of injury!

Check stability of ground. Park the vehicle on stable
grounds only, additionally secure it against rolling away
by means of a wheel chock.
ATTENTION
Use a suitable commercially available vehicle jack.

Park the vehicle on a level surface.

Activate parking brake.
If the motor is off, it is automatically applied.
Note
The four-wheel brake acts on all wheels.

Remove ignition key.

Position vehicle jack at the appropriate mounting point
for the front or rear wheel.

Loosen the wheel nuts/wheel bolts by about 1 revolu-
tion using a suitable tool.

Lift the vehicle by means of a jack, additionally support
with stands.

Unscrew the wheel nuts/wheel bolts and remove them.

Remove wheel.
Note
For values concerning the tyre pressure and the weight
of the various tyres and rims see Chapter "Technical
data".

Have the defective wheel repaired by a specialised re-
pair shop.

Position the wheel and ensure that the rim is centred,
then screw in the wheel nuts/wheel bolts to the stop and
tighten them crosswise.

Torque the wheel nuts/wheel bolts to the required
torque.
Tightening torque: Front and rear wheels 180 Nm

Lower vehicle with jack.
1 Screw
2 Cover
3 Oil dipstick

Park the vehicle on a level surface.

Remove cover; in order to do so, unlock the two screws
by a counterclockwise rotation.

Pull out oil dipstick.

Wipe off oil dipstick and insert.

Pull out oil dipstick.

Read the value of the oil level.

Insert the oil dip again.
–
The oil level must lie between “MIN“ and “MAX“ marking.
–
Add motor oil if the oil level is below the "MIN" marking.
1 Mounting of the fuel tank
2 Fuel tank

Remove the left lateral motor panel.

Open the screw of the mounting part of the fuel tank
and swivel the fuel tank towards the outside.
1 Oil filler cap
2 Oil filler cover (MC 130 advanced plus)

Remove the oil filler cap.

Fill in motor oil.
Oil grade: Refer to chapter "Technical data"

Do not fill oil above the "MAX" marking.

Close oil cap.

Wait at least 5 minutes.

Check engine oil level.
11.4.6 Replacing wheel
11.4.7 Check the motor oil level
BILD anpassen
11.4.8 Fill in motor oil
90 EN