Kärcher MC 130, Manual

Page: 81 / 414

-
29
1 Waste container
2 Safety pin
3 Safety splint
4 Frame
5 Hydraulic connection

Open the safety cotter and pull out the safety bolt of the
waste container on the left and right.

Insert the rear supports on the left and right into the
frame up to the stop.

Press the "Raise attachment frame" switch and raise
the attachment frame until the lateral supports can be
slid into the waste container.

Slide in the lateral supports on the left and right up to
the stop.

Completely lower the attachment frame.
Note
The waste container rests freely on the supports now.

Carefully drive the vehicle away from the waste con-
tainer.
Figure: Waste container on supports

The installation of the waste container on the vehicle
takes place in the reverse order.
To remove/attach the sweeping system, a changing car-
riage is required (optional accessory, order no. 2.852-
065.0).

Place the vehicle on a level and solid surface to re-
move/attach the sweeping system.

Maximally raise the side brushes and move both side
brushes outwards.
1 Lever position sweeping system unlocked
2 Lever position sweeping system locked
3 Front of the vehicle
1 Pole
2 Lock lever

Unlock the sweeping system by inserting the rod and
pulling the locking lever upwards.
Note
The rod needed for this is clamped in a holder between
the driver's seat and passenger seat.

Move in the changing carriage centrally up to the stop
using a pallet truck.

Use some momentum for the last part (centring proce-
dure).
Important note
Risk of damage! Mind lines and hoses.

Lift the pallet truck until the changing carriage touches
the sweeping system.
8.2.3 Installing the waste container
8.3 Sweeping system
8.3.1 Preparation
8.3.2 Removing the sweeping system
81 EN