Chapter 8 DETAIL PERFORMANCE SETTINGS
170
8.7.6.1 INTERNAL MEMORY TO USB
USB flash memory is not recognized when you inserted USB flash memory
from display unit power off state.
It may take long time to access USB flash memory during transmission.
We recommend that you use USB flash memory during stand-by.
You can copy the system settings which were saved in the internal memory (such as various item settings
of menus, etc.) to a USB flash memory. To copy the settings which were saved in the internal memory, a
USB flash memory must be inserted into "USB" port on the control panel beforehand. When you replaced
the processing circuit inside the display unit, you can restore the system by load the data stored in the USB
flash memory and write it to the system memory.
It should be saved to USB flash memory when the system settings are completed. And we strongly
recommend that you save the operating conditions to a USB flash memory on a regular basis.
Items which can be saved to a USB flash memory are following.
RADAR Echo:
RADAR Echo settings in Main Menu and Adjust Setting
will be saved to
the USB.
Function Setting:
Function Setting settings
will be saved to the USB.
Basic Adjustment:
Basic Adjustment settings
will be saved to the USB.
Main Menu:
Main Menu, MULTI control menu, and radar screen settings (except
RADAR Echo and Function Setting settings)
will be saved to the USB.
Adjust Setting:
Adjust Setting Menu (except RADAR Echo and Basic Adjustment
settings)
will be saved to the USB.
System Information 1:
Utility Menu will be saved to the USB.
System Information 2:
Engineer Menu will be saved to the USB.
All Menu:
Internal all settings will be saved to the USB
.
Note:
When the USB flash memory is inserted, the dedicated folder to save / read the internal value will be
created. However, as the capacity of the USB flash memory is large, it takes time to create the
dedicated folder.
8.7.6.2 USB TO INTERNAL MEMORY
When executed, the display unit will automatically restart.
Load the data stored in the USB flash memory and write it to the system internal memory.
Through this operation, you can return the system to the previous operation condition after replaced the
processing circuit.
Summary of Contents for JMA-3400 Series
