JRC JMA-3400 Series, Instruction Manual, Page: 216 / 314

Chapter 8 DETAIL PERFORMANCE SETTINGS
168
8.7.4 SCANNER TIME CLEAR
Save the following scanner time data stored in the scanner into the display unit.
Scanner Transmit Time
Motor Rotating Time
When replacing the scanner internal control circuit, perform the procedure below to inherit scanner time
data.
1. Save the scanner time data.
2. Replace the scanner internal control circuit.
3. Restore the scanner time data.
Restore the scanner time data stored in the display unit into the scanner internal control circuit.
Initialize those operating time above when magnetron or scanner motor is replaced.
* The same dialogue is
shown about each menu.
([HFXWHWKLVIXQFWLRQ$UH\RXVXUH"