IDEC MICRO/I HG4G-CJT22 F-B Series, User Manual, Page: 427 / 1665

WindO/I-NV4 User’s Manual
8-25
2 Word Button
8
Bu
tton
s
■
Data Type
Select the data type to be handled by the operation selected for Action Mode .
For details, refer to Chapter 2 “1.1 Available Data” on page 2-1.
UBIN16(W) and UBIN32(D) can only be set if Action Mode is set to OR , AND , or XOR .
■
Source 1
Specify the source word device.
Click
to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-68.
This setting is enabled only if Action Mode is set to Add , Sub , Multi , Div , Mod , OR , AND , or XOR .
■
Source Data
Select the data to be handled by the operation selected for Action Mode .
*1 Advanced mode only
UBIN16(W) and UBIN32(D) can only be set if Action Mode is set to Move . Because the number of
device addresses to transfer is specified in Advanced mode, you do not need to set Data Type.
If BCD4(B) , BCD8(EB) , or Float32(F) is selected and the arithmetic data contains a value inexpressible
in BCD, a 1 is written to the System Area 2 Processing error bit (address 2, bit 5) and an error
message is displayed. For details, refer to Chapter 4 “Processing error” on page 4-32 and Chapter 36
“Processing error” on page 36-3.
Value: Use a constant value.
Only a Value can be handled if Action Mode is set to Set , Momentary , or Alternate .
If Action Mode is set to Momentary or Alternate , the value in the ON Data is written when the
button is ON, and the value in the OFF Data is written when the button is OFF.
Hexadecimal: Select this check box to enter the ON Data and OFF Data values in
hexadecimal.
Device Address: Use a value of device address.
Specify the device address.
Click
to display the Tag Editor. For the device address configuration procedure, refer to Chapter
2 “5.1 Device Address Settings” on page 2-68.
Use Reference Device Address
*1
: Select this check box and specify a device address to change the
source word device according to the value of the specified device
address.
This setting is enabled only if Action Mode is set to Move .
For details, refer to Chapter 2 “Indirect Read and Indirect Write
Settings” on page 2-5.
Transfer
*1
Specify the number of word devices (1 to 64) to transfer.
This setting is enabled only if Action Mode is set to Move .
Example: If Transfer is set to 2 and Write is set to 3 , the same data in
2 continuous word device addresses will be written to the
destination device address 3 times.
:
Device Address: LDR0
Write: 3
999 LDR0
Destination Device: D100
D100
D101
D102
D103
Transfer: 2
1000 LDR1
D104
D105
999
1000
999
1000
999
1000