S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
5-13
Cisco MDS 9000 Family CLI Configuration Guide
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 5 Initial Configuration
Initial Setup Routine
Step 19
Enter
deny
(deny is the default) to deny a default zone policy configuration.
Configure default zone policy (permit/deny) [deny]:
deny
Denies traffic flow to all members of the default zone.
Step 20
Enter
no
(no is the default) to disable a full zone set distribution (see the
“Zone Set Distribution” section
on page 23-13
).
Enable full zoneset distribution (yes/no) [n]:
no
Disables the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Step 21
Enter
no
(no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
snmp-server community snmp_community rw
switchname switch
interface vsan1
ip address ip_address subnet_mask
no shutdown
ip default-gateway default_gateway
no telnet server enable
ssh key rsa 1024 force
ssh server enable
system default switchport shutdown
system default switchport trunk mode auto
system default switchport mode F
no zone default-zone permit vsan 1-4093
no zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]:
no
Step 22
Enter
yes
(yes is default) to use and save this configuration.
Use this configuration and save it? (yes/no) [y]:
yes
Caution
If you do not save the configuration at this point, none of your changes are updated the next
time the switch is rebooted. Type
yes
to save the new configuration. This ensures that the
kickstart and system images are also automatically configured (see
Chapter 7, “Software
Images”
).
Using the setup Command
To make changes to the initial configuration at a later time, you can issue the
setup
command in EXEC
mode.
switch#
setup
---- Basic System Configuration Dialog ----
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
*Note: setup always assumes a predefined defaults irrespective
of the current system configuration when invoked from CLI.
Press Enter incase you want to skip any dialog. Use ctrl-c at anytime
to skip away remaining dialogs.
