S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
5-8
Cisco MDS 9000 Family CLI Configuration Guide
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 5 Initial Configuration
Initial Setup Routine
Enable the ip routing? (yes/no) [y]:
yes
c.
Enter
yes
(yes is the default) to configure a static route (recommended).
Configure static route: (yes/no) [y]:
yes
Enter the destination prefix.
Destination prefix:
dest_prefix
Type the destination prefix mask.
Destination prefix mask:
dest_mask
Type the next hop IP address.
Next hop ip address:
next_hop_address
Note
Be sure to configure the IP route, the default network IP address, and the default gateway IP
address to enable SNMP access. If IP routing is enabled, the switch uses the IP route and the
default network IP address. If IP routing is disabled, the switch uses the default gateway IP
address.
d.
Enter
yes
(yes is the default) to configure the default network (recommended).
Configure the default network: (yes/no) [y]:
yes
Enter the default network IPv4 address.
Note
The default network IPv4 address is the destination prefix provided in
Step 11c
.
Default network IP address [dest_prefix]:
dest_prefix
e.
Enter
yes
(yes is the default) to configure the DNS IPv4 address.
Configure the DNS IP address? (yes/no) [y]:
yes
Enter the DNS IP address.
DNS IP address:
name_server
f.
Enter
yes
(default is no) to configure the default domain name.
Configure the default domain name? (yes/no) [n]:
yes
Enter the default domain name.
Default domain name:
domain_name
Step 12
Enter
yes
(yes is the default) to enable the Telnet service.
Enable the telnet service? (yes/no) [y]:
yes
Step 13
Enter
yes
(no is the default) to enable the SSH service.
Enabled SSH service? (yes/no) [n]:
yes
Step 14
Enter the SSH key type (see the
“Overwriting a Generated Key-Pair” section on page 39-16
) that you
would like to generate.
Type the SSH key you would like to generate (dsa/rsa/rsa1)?
dsa