Hitachi GX1000-SMC013X, Instruction Manual

Page: 124 / 452

124
<destination port start> <destination port end>
}] [{traffic-class
<traffic class>
| dscp
<dscp>
}] [vlan {
<vlan id>
|
<vlan id list
name>
}] [user-priority
<priority>
][{ctag-untagged |
[ctag-user-priority
<priority>
] [ctag-vlan
<vlan id>
]}]
-
When the upper-layer protocol is ICMP
mac-ipv6 {
<source mac> <source mac mask>
| host
<source mac>
| any} {
<destination mac> <destination mac mask>
| host
<destination mac>
| any | bpdu | cdp | lacp | lldp | oadp |
pvst-plus-bpdu | slow-protocol} icmp {
<source ipv6>
/
<length>
|
host {
<source ipv6>
| own-address} | any | own-address
<own
address length>
| own | range-address
<source ipv6 start> <source
ipv6 end>
} {
<destination ipv6>
/
<length>
| host {
<destination ipv6>
|
own-address} | any | own-address
<own address length>
| own |
range-address
<destination ipv6 start> <destination ipv6 end>
}
[{
<icmp type>
[
<icmp code>
] |
<icmp message>
}]
[{traffic-class
<traffic class>
| dscp
<dscp>
}] [vlan {
<vlan id>
|
<vlan id list name>
}] [user-priority
<priority>
][{ctag-untagged
| [ctag-user-priority
<priority>
] [ctag-vlan
<vlan id>
]}]
action-specification
action log
To delete information:
no
<sequence>
Input mode
(config-adv-acl)
Parameters
<sequence>
Sets the sequence in which filter conditions are applied.
1. Default value when this parameter is omitted:
10 is set as the initial value if there are no conditions in the access list.
If conditions have been set, the initial value is the maximum value for the
application sequence that has been set plus 10.
Note, however, that if the maximum value for the application sequence is
greater than 4,294,967,284, the value cannot be omitted.
2. Range of values:
Specify 1 to 4,294,967,294 (in decimal).
{
<source mac> <source mac mask>
| host
<source mac>
| any}
Specifies the source MAC address.
To specify all source MAC addresses, specify
any
.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify <source mac> <source mac mask> ,
host
<source mac> , or
any
.
Specify the source MAC address for <source mac> .
For <source mac mask> , specify a mask in MAC address format that specifies
bits in the MAC address whose permitted value is arbitrary.
If
host
<source mac> is specified, the filter condition is an exact match of