Hitachi GX1000-SMC013X, Instruction Manual

Page: 398 / 452

398
{<
IP address on the WAN side
>/<
Subnet length
> | any}
Specifies an IPv4 address and subnet length of the WAN side as conditions.
1. Default value
This parameter cannot be omitted.
2. Specifiable value range
An IP address on the WAN side
0.0.0.0-255.255.255.255
Subnet length
0-32
any
Specifies all IPv4 addresses.
port <
TCP port number
>
Specifies as a condition the port number on the server side (DestPort of a SYN
packet) of a TCP session in addition to the default value in Table 26-3.
1. Default value
Uses the default value in Table 26-3 for the condition of the port number on the
server side of a TCP session.
2. Specifiable value range
0-65535
{accelerate | passthrough}
Specifies WAN acceleration processing for a TCP session that satisfies conditions.
1. Default value
This parameter cannot be omitted.
2. Specifiable value range
accelerate
Specifies WAN acceleration processing operation for a session with the IP
address and the TCP port number specified by
from
and
to
.
passthrough
Specifies pass-through operation for a session with the IP address and the
TCP port number specified by
from
and
to
.
compress
Specifies data compression operation when sending packets subject to WAN
acceleration processing to the WAN side. Note that operation differs depending on
whether
port
is specified.
If
port
is specified, data compression is performed.
If
port
is not specified, data compression operation is performed according to the
configuration of the
compress-port
command. (See Table 26-10.)
1. Default value