Hitachi GX1000-SMC013X, Instruction Manual

Page: 142 / 452

142
2. Range of values:
Set 0 to 255 (in decimal) or a protocol name.
For details about the protocol names that can be specified, see Protocol
names that can be specified (IPv4).
{ipv6 |
<protocol>
| icmp | tcp | udp}
You can select this parameter when
mac-ipv6
is specified as the flow detection
condition.
Specifies the upper-layer protocol condition for IPv6 packets.
Note that if all protocols are applicable, specify
ipv6
.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify 1 to 42, 45 to 49, 52 to 59, 61 to 255 (in decimal), or a protocol name.
For details about the protocol names that can be specified, see Protocol
names that can be specified (IPv6).
{{
<source ipv4>
| own-address}
<source ipv4 wildcard>
| host {
<source ipv4>
|
own-address} | any | own | range-address
<source ipv4 start> <source ipv4 end>
}
Specifies the source IPv4 address.
To specify all source IPv4 addresses, specify
any
.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify <source ipv4> <source ipv4 wildcard> ,
host
<source ipv4> ,
any
,
own-address
<source ipv4 wildcard> ,
host own-address
,
own
, or
range-address
<source ipv4 start> <source ipv4 end> .
Specify the source IPv4 address for <source ipv4> .
For <source ipv4 wildcard> , specify a wildcard mask in IPv4 address format
that specifies bits in an IPv4 address whose permitted value is arbitrary.
If
host
<source ipv4> is specified, the filter condition is an exact match of
<source ipv4> .
If
any
is specified, the source IPv4 address is not used as a filter condition.
own-address
and
own
are valid only for
access-group
commands for a VLAN
interface.
range-address
is valid only for
access-group
commands for an Ethernet
interface or a VLAN interface.
If
own-address
is specified, the filter condition is the source IPv4 address that
has been set on the target interface.
If
own
is specified, the filter condition is the network address part of the IPv4
address that has been set on the target interface. The host address part of the
IPv4 address in the filter condition is assumed to be arbitrary.
If the interface with the
own-address
or
own
parameter specified is
multihomed, the primary IPv4 address is assumed.
If
range-address
is specified, the filter condition is in the range from <source
ipv4 start> to <source ipv4 end>
Specify IPv4 addresses so that <source ipv4 end> is larger than <source ipv4
start> .