Hitachi GX1000-SMC013X, Instruction Manual

Page: 185 / 452

185
12.3.3 Checking the status of the SP functionality
To check the SP functionality status, use the
show nif
operation command. An example is
shown below:
Figure 12-3 Checking the SP functionality status (1)
>show nif 1
Date 2011/04/05 12:00:00 UTC
NIF1: active 2-port 10GBASE-R(SFP+) + 1-port 10GBASE-R-SP retry:0
Average:103Mbps/24Gbps Peak:150Mbps at 08:10:30
Port1: active up 10GBASE-SR 0012.e240.0a04
SFP+ connect
Bandwidth:10000000kbps Average out:20Mbps Average in:10Mbps
description: test lab area network
:
:
Port3: active up 10GBASE-R-SP 0012.e240.0a06
SP: In Service
Bandwidth:10000000kbps Average out:3500Mbps Average in:3500Mbps
>
To check the SP functionality status, use the
show interfaces
operation command. An
example is shown below:
Figure 12-4 Checking the SP functionality status (2)
>show interfaces tengigabitethernet 1/3 detail
Date 2011/04/05 12:00:00 UTC
NIF1: active 2-port 10GBASE-R(SFP+) + 1-port 10GBASE-R-SP retry:0
Average:7000Mbps/20Gbps Peak:7500Mbps at 08:10:30
Port3: active up 10GBASE-R-SP 0012.e240.0a04
SP: In Service
Time-since-last-status-change:10:30:30
Bandwidth:10000000kbps Average out:3500Mbps Average in:3500Mbps
Peak out:3800Mbps at 08:10:30 Peak in:3700Mbps at 08:10:30
Output rate:2900Mbps 3400pps
Input rate:2900Mbps 3400pps
Flow control send :on
Flow control receive:on
TPID:8100
Frame size:1518 Octets retry:0 Interface name:tengeth1/3
<Out octets/packets counter>
Octets : 0
:
: