Hitachi GX1000-SMC013X, Instruction Manual

Page: 176 / 452

176
10.1 Command input mode
10.1.1 List of operation commands
Table 10-1 List of operation commands
Command name Description
session
Changes the command input mode from general user mode to SP user
mode or from device administrator mode to SP administrator mode.
10.1.2 Command input mode
To change the configuration or check the status of the Device, you must be in the
appropriate command input mode, and then enter a configuration command or operation
command.
To operate an SP, change the command input mode to SP mode before executing a
command. Change to a mode by using the
session
operation command.
From the CLI prompt, you can tell which command input mode you are in.
The following table describes the correspondences between command input modes and
the prompts.
Table 10-2 Correspondences between command input modes and CLI prompts
Command input mode Executable command Prompt
SP user mode SP operation commands (
configure
and some
commands can only be executed in SP
administrator mode.)
SPXX>
#1
SP administrator mode
SPXX
#1
SP configuration mode SP configuration commands
Some SP operation commands
[SPXX]
#1
#1:
The NIF slot number replaces the
XX
for the prompt
SPXX
. Use the same prompt to
log in directly to the SP for a login from another device.
Example
> session 1/3
SP01>
> enable
# session 1/3
SP01# exit
# quit
>
The following figure provides an overview of mode transitions.