Hitachi GX1000-SMC013X, Instruction Manual

Page: 144 / 452

144
If
neq
is specified, the filter condition is other than <source port> .
If
range
is specified, the filter condition is in the range from <source port start>
to <source port end> .
Specify port numbers so that <source port end> is larger than <source port
start> .
{{
<destination ipv4>
| own-address}
<destination ipv4 wildcard>
| host {
<destination
ipv4>
| own-address} | any | own | range-address
<destination ipv4 start>
<destination ipv4 end>
}
Specifies the destination IPv4 address.
To specify all destination IPv4 addresses, specify
any
.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify <destination ipv4> <destination ipv4 wildcard> ,
host
<destination
ipv4> ,
any
,
own-address
<destination ipv4 wildcard> ,
host own-address
,
own
, or
range-address
<destination ipv4 start> <destination ipv4 end> .
Specify the destination IPv4 address for <destination ipv4> .
For <destination ipv4 wildcard> , specify a wildcard mask in IPv4 address
format that specifies bits in an IPv4 address whose permitted value is
arbitrary.
If
host
<destination ipv4> is specified, the filter condition is an exact match of
<destination ipv4> .
If
any
is specified, the destination IPv4 address is not used as a filter
condition.
own-address
and
own
are valid only for
access-group
commands for a VLAN
interface.
range-address
is valid only for
access-group
commands for an Ethernet
interface or a VLAN interface.
If
own-address
is specified, the filter condition is the destination IPv4 address
that has been set on the target interface.
If
own
is specified, the filter condition is the network address part of the IPv4
address that has been set on the target interface. The host address part of the
IPv4 address in the filter condition is assumed to be arbitrary.
If the interface with the
own-address
or
own
parameter specified is
multihomed, the primary IPv4 address is assumed.
If
range-address
is specified, the filter condition is in the range from
<destination ipv4 start> to <destination ipv4 end> .
Specify IPv4 addresses so that <destination ipv4 end> is larger than
<destination ipv4 start> .
IPv4 address ( nnn . nnn . nnn . nnn ): 0.0.0.0 to 255.255.255.255
{
<destination ipv6>
/
<length>
| host {
<destination ipv6>
| own-address} | any |
own-address
<own address length>
| own | range-address
<destination ipv6 start>
<destination ipv6 end>
}
Specifies the destination IPv6 address.
To specify all destination IPv6 addresses, specify
any
.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.