Hitachi GX1000-SMC013X, Instruction Manual

Page: 167 / 452

167
policy-interface (policy-list)
Specifies the routing information for policy-based routing.
Routes with routing information are selected in ascending order of the sequence in which
they are applied in policy-based routing list information.
A maximum of eight routing information items can be set for one policy-based routing list.
Input format
To set or change information:
[
<sequence>
] policy-interface vlan
<vlan id>
next-hop
<next hop ipv4>
[track-object
< track object id >
]
To delete information:
no
<sequence>
Input mode
(config-pol)
Parameters
<sequence>
Specifies the sequence in which the routing information items for policy-based
routing are applied.
1. Default value when this parameter is omitted:
If no routing information has been set for policy-based routing, the initial value
is set to 10.
If routing information has been set, the initial value is the maximum value for
the application sequence that has been set plus 10.
Note, however, that if the maximum value for the application sequence is
greater than 4,294,967,284, the value cannot be omitted.
2. Range of values:
Specify 1 to 4,294,967,294 (in decimal).
vlan
<vlan id>
Specifies the VLAN ID for the packet destination.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify a destination VLAN ID.
For details about VLAN IDs, see 6.3 Specifiable values for parameters.
next-hop
<next hop ipv4>
Specifies the next-hop IPv4 address of the packet destination.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify a next-hop IPv4 address.
Specify an address in the network that connects to the specified destination
interface. However, you cannot specify the direct broadcast address of the