Hitachi GX1000-SMC013X, Instruction Manual

Page: 408 / 452

408
wan-speed
Description
Sets an upper limit for bandwidth that sends a packet of a session subject to WAN
acceleration processing to an interface on the WAN side.
Input mode
SP configuration mode
Syntax
wan-speed {<
bandwidth
> { K | M }}
wan-speed default
Parameters
< bandwidth >
Specifies bandwidth that sends a packet to an interface on the WAN side.
1. Default value
This parameter cannot be omitted.
2. Specifiable value range
1-1000
{K | M}
Specifies bandwidth unit.
1. Default value
This parameter cannot be omitted.
2. Specifiable value range
K
Specifies Kbps (10^3 bits/second).
M
Specifies Mbps (10^6 bits/second).
default
Deletes the configuration and resets to the default value (100 Mbps).
Notes
If bandwidth smaller than 1 M is set by the parameter, depending on the network status,
sending might be performed in the value greater than the set value.
The real upper limit for bandwidth that sends a packet to an interface on the WAN side
becomes the total value of the bandwidth set by executing this command and the
bandwidth set by executing bandwidth-grp.