6 Using the heating system – °C/QUANTITY menu
88
HDG Compact 99 - 200 - Version 1 - en
©
HDG Bavaria GmbH 07/2008
S
ELECTING
A
MATERIAL
TYPE
In this menu you can choose from four different heating material set-
tings. The varying quality of the heating material can also be taken
into account. All parameters can be newly defined and reset for each
type of material.
✎
See “Procedure” in this section.
D
EFINING
THE
SWITCH
ON
/
OFF
TIMES
FOR
THE
BOILER
This menu is used to define the switch on/off times of the boiler
based on the temperature sensor of the accumulator. The switching
on and off of the boiler can be changed by adapting the tempera-
ture.
•
Temp. acc. top below
– If this temperature set for the top accumulator sensor is not
met, the boiler switches back on.
•
Temp. acc. bottom above
– If the temperature set for the bottom accumulator sensor is ex-
ceeded, the boiler switches off.
In this menu, the settings of the fuel and air quantities are fixed
value presets for “Fixed value” operation only.
✎
See section “6.6 ON/OFF menu”, under “Setting the control,
boiler activation, ignition and Lambda Stop”.
Material type
2-
05
Material
1 : ( Material_1 )
END
The standard setting for start-up is usually
Material: 1
.
Independent modification of settings for adapting to the fuel
should be made under another fuel type so as not to change the
startup settings. For example, save the start-up setting under
Ma-
terial:
2
and only then modify this setting.
