4 Planning and installation – Installing the heating system
52
1. Remove both clamping devices (1) from the ash removal doors
using an SW13 spanner.
2. Push the auger trough (5) through the flange plates (1) and seals
into the ash accumulation bins (3, 4).
3. Install the flange plates (1) with the M10 screws (spanner size
SW17) and washers on the ash accumulation bins (3, 4).
4. Install the torque support (2) using the M10 hexagon socket
screws (spanner size SW6) on the ash accumulation bin (3).
5. Install the auger trough (5) using the M8 hexagon socket screws
(spanner size SW5) on the torque support (2).
6. Push the ash removal auger (6) through the auger trough (5).
Figure 4/21 - Removing clamping devices
1
Figure 4/22 - Pre-assembling the central ash removal system
6
5
3
2
1
4
Important!
Then secure all screws for the assembly of the central ash removal
system, without tightening them.
