GSK 980MDc, User Manual

Page: 461 / 473

GSK980MDc Milling CNC System User Manual
442
Appendix
2: when the tools are mixed, adjust the toolcase No. (by parameter D409). The operations like this:
press key and do not release till arrive at where needed by moving the up and down keys. In this
way, the sequence of fallen toolcase No. can be adjusted.
3: If the toolcase No. and tool No. is not consistent, you can adjust them at real time. If there are
some tools No. are the same in toolcase sequence, TOOL MAGAZINE will alarm that “Tool No. inputted is
reduplicated with the other, please adjust it again”.
„
Toolpot zero position
It is only in back to reference point mode, do the toolpot back to zero position can be implemented.
So when execute this function, please make sure whether zero signal exists or not. CNC cannot
implement this function without a zero signal.
1: only when the toolcase is risen up, that do toolpot can back to zero position, otherwise not.
2: if the toolpot wants back to zero position, the CNC will detect X0.0 signal. If this signal turns one
circle and the toolpot keeping spinning and cannot find 0 point, please check the zero signal in
machine tools electric is correct or not.
3: After the toolpot back to zero point, the target and current toolcase data will be all set to1,
indicating that the current toolcase No. 0 is 1.If the data corresponding to the toolpot is not 1,
please check machine tools electric is correct or not.
4: there is no key in 980MDc-V panel. If other keys needed to be set, the ladder diagram
should be altered.
„
Manual toolpot rotation
In 980MDc_V system, in the mode of MPG, STEP or MANUAL, press the tool magazine rotation key,
the toolpot will rotate CW a tool location. If the toolpot will not rotate:
1: please make sure the tool magazine parameter K11.6 and K11.7 set in pot tool magazine valid;
2: please make sure that the CNC is in the mode of MPG, STEP or MANUAL;
3: press the key, check up in ladder->PLC, to see Y1.6 has an output or not. If Y1.6 has an output,
please check the machine tools electric part that whether it has inputted to toolpot motor to start toolpot