GSK 980MDc, User Manual

Page: 266 / 473

Chapter 7 Auto Operation
247
Ⅱ
Operation
CHAPTER 6 PROGRAM EDIT AND MANAGEMENT
In Edit mode, the programs can be created, selected, modified, copied and deleted, and the
bidirectional communication between CNC and CNC, or CNC and PC can also be achieved. To prevent
the program to be modified or deleted accidentally, a program switch is set for this GSK980MDd system.
And it must be turned on before program editing. Also 3 level user authority is set in this GSK980MDc
system to facilitate the management. Only the operation authority is above 4 level (4 or 3 level etc.) can
open the program switch for program editing.
6.1 Program Creation
6.1.1 Creation of a Block Number
The program can be with or without a block No. The program is executed by the block numbered
sequence (except the calling). When the “AUTO SEG” switch in setting page is OFF, the CNC doesn’t
generate the block number automatically, but the blocks may be edited manually.
When “AUTO SEG” switch in switch setting page is on, the CNC generates the block number
automatically. In editing, press key to generate block number of the next block automatically. The
increment of this block number is set by № 3216.
6.1.2 Input Program Content
1. Press key to enter the Edit mode;
2. Press key to enter the Program interface, select the PRG CONTENT page by
pressing or key