GSK 980MDc, User Manual

Page: 264 / 473

Chapter 5 MDI Operation
245
Ⅱ
Operation
2. In MDI page, the system automatically address the program O0000 which is exclusive to MDI mode.
In Auto mode, the program O0000 cannot be opened and edited. When O0000 is in the U disk, it is shielded
and cannot be displayed in viewing the U disk.
3. Use the general edit operation to compile the program O000. In MDI mode, compiling a program can
execute the following operations including insertion, modification, deletion, clearing programs, cancel,
resume, copying blocks, pasting blocks and deleting blocks. M99 is added to end of the block, which is used
to return to home of the program and execute the cycle start of MDI programs.
4. The cursor moves to the required program position to execute the program, press the cycle start key
on the operation panel, and so the program starts run. After statements for end of program(M02 or M30) is
executed, program run ends.
5. The main program in MDI mode alone specifies M99, deleting programs is not controlled by #810.4
MER. When M99 P program is specified, the system executes skip.
6
．
In MDI mode, compiled programs can be deleted as follows:
When No.810 MER is set to 0, the program which last block is executed is automatically deleted (it is
not deleted when it is specified to executed). When No.810 MER is set to 1, the program which last block is
executed is not deleted (No.810 MKP is 0, M02/M30 is executed and the program is also deleted);
Press the soft press key-deletion program in MDI page, the MDI program input box is deleted;
When No. 810 MCL is set to 1 and reset operation is executed, MDI program input box is deleted;
In Auto mode or DNC mode, start running programs, programs in MDI program input box are
automatically deleted.
7. Restart: In MDI stop mode, after editing MDI programs are executed, the run is started again from the
position of current cursor.
8. In MDI mode, after a program is compiled, a empty area in the program storage is used. When
the storage is full, any programs cannot be compiled in MDI mode.
5.6 Subprograms Call in MDI Mode
In MDI mode, compiled M98 can execute subprogram call function. Up to 4-level subprograms
can be called.
In MDI mode, macro programs can be compiled, called and executed.
In MDI page, when the called subprogram runs, the subprogram must not be edited. O0000
cannot call subprograms.