154 ENGLISH
3.
Check the
<Enable NTP> checkbox to enable this feature.
4.
Configure the following <NTP Settings>:
<Interval>:
Time interval between the two synchronizing actions with the <NTP Server>. The unit is
one minute.
<NTP Server>:
<IP Address> of the <NTP Server>.
<NTP Port>:
<Port> of the <NTP Server>.
5.
Click the <Apply> button to save and exit the interface.
Note:
The time synchronization interval can be set from <1> to <10080> minutes and the default value is <60>
minutes. If the NVR is connected to a public network, you should use a <NTP Server> that has a <Time
Synchronization> function, such as the server at the National Time Center (IP Address: 210.72.145.44). If the
NVR is set up in a more customized network, <NTP> software can be used to establish a <NTP Server> used
for <Time Synchronization>.
12.2.3 Configuring SNMP
You can use <SNMP> protocol to get the device status and parameters related information.
Steps:
1.
Enter the <Network Settings> interface: Menu >Configuration> Network
2.
Select the <SNMP>
tab to enter the <SNMP Settings> interface.
SNMP Settings Interface
3.
Check the <SNMP> checkbox to enable this feature.
4.
The enabling of <SNMP> may cause security problems. Click <Yes> to continue or <No> to cancel
the operation.
SNMP Settings Interface
5.
When you choose the <Yes> option in Step 4, then configure the following <SNMP Settings>:
<Trap Address>:
<IP Address> of <SNMP Host>.
<Trap Port>:
<Port> of <SNMP Host>.
