GRAPHTEC FC2250 Series, User Manual

Page: 46 / 130

3-18
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(7) Press the [F2] key (BALL) for GP-GL, and the [F4] key (BOX) for HP-GL.
When GP-GL has been selected When HP-GL has been selected
FORCE OFFSET
SPEED QUALITY
BALL S
BALL L
FORCE OFFSET
SPEED QUALITY
BOX_A
BOX_B
(8) Check the condton of the cut samples.
Blade Length Adjustment
(1) Wth the plotter n Ready status, press a key from [F1] to [F4] to select the COND No. for blade length adjustment.
(2) Press the [TEST] key to dsplay the cuttng test selecton screen.
FORCE OFFSET
SPEED QUALITY
TEST1 TEST2
SAMPLE BLADE ADJ.
(3) Press the [F4] key (BLAD ADJ.). The pen carrage wll move to the blade length adjustment poston, and the dsplay
wll alternate between the followng two screens.
FORCE OFFSET
SPEED QUALITY
FORCE OFFSET
SPEED QUALITY
TURN BLADE KNOB CCW
TO SHORTEN BLADE TIP
THEN
PRESS ENTER KEY!
(4) After you have fully retracted the blade tp, press the [ENTER] key to dsplay the followng screen.
FORCE OFFSET
SPEED QUALITY
0.00 mm
CHECK
(5) Turn the blade length adjustment knob n the clockwse drecton to extend the blade tp. Press the [F4] key (CHECK)
to dsplay the currently extended length of the blade. Adjust ths amount to sut the thckness of the medum.
The blade is extended The blade is retracted
When the knob is given one full turn, the blade retracts or extends 0.5 mm.
(6) When blade length adjustment has been completed, press the [ENTER] key or the [NEXT] key .
•
If you perform a check with the cutter blade in the extended status, the blade tip may stick in the medium, making it
difficult to obtain an accurate value.
•
If a check is performed repeatedly at the same location, the blade tip may stick in the medium, making it difficult to
obtain an accurate value.