GRAPHTEC FC2250 Series, User Manual

Page: 64 / 130

4-13
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
(6) Press the [F3] key (ADJ. SENS) to dsplay the menu shown below.
FORCE OFFSET
SPEED QUALITY
X ADJUST SENS. Y
X+ Y+
(7) Press the [F2] key (X+) to adjust the X-axs sensor, and the [F4] key (Y+) to adjust the Y-axs sensor. The prompt
shown below s dsplayed.
FORCE OFFSET
SPEED QUALITY
CHANGE TOOL
PRESS ENTER KEY!
(8) Mount a plottng pen n tool holder 1.
(9) Press the
[CONDITION] key to dsplay a condton settngs screen, and then use the [F1] to [F4] keys to select a
COND No. where "PEN" has been selected as the cutter blade type.
(10) Use the [ ] [ ] [ ] [ ] keys to move the pen carrage (the tp of the tool selected by the current settng) to the
poston where you want to plot the cross symbol and then press the [ENTER] key . The plotter plots a cross symbol,
and then the prompt shown below s dsplayed.
FORCE OFFSET
SPEED QUALITY
CHANGE TOOL
PRESS ENTER KEY!
(11) Replace the plottng pen wth a cutter pen.
(12) Press the
[CONDITION] key to dsplay a condton settngs screen, and then use the [F1] to [F4] keys to select a
COND No. where a cutter blade has been selected as the cutter blade type. Press the [ENTER] key . The sensor
reads the plotted cross symbol, and then cuts a second cross symbol. After the second cross symbol has been cut,
the screen shown below s dsplayed.
FORCE OFFSET
SPEED QUALITY
SENSOR OFFSET ADJUST
X= 0.0 mm Y= 0.0 mm
Input the difference in values between the first and second crosses. If there is no difference, simply press the [ENTER]
key .
Press the [F2] or [F4] key to move the blnkng cursor to X or Y, and then use the [ ] or [ ] key to change the
numerc value. When the dsplayed settng s satsfactory, press the [ENTER] key to confirm your selection.
Setting range: -9.9 to +9.9 (mm)
Cross that was cut after the first cross was read
Value for X-axis correction
Value for Y-axis correction
Y
X
Cross that was plotted first
(13) Press the [PAUSE] key to cancel PAUSE mode.