GRAPHTEC FC2250 Series, User Manual

Page: 57 / 130

4-6
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
Setting the Registration Mark Spacing
(1) If regstraton mark 3, mrror 1 or mrror has been selected, the menu for settng the regstraton mark pattern spacng
s dsplayed.
FORCE OFFSET
SPEED QUALITY
MARK TYPE:3
SPACING = 3.0 mm
Use the [ ] or [ ] key to change the numerc value. When the dsplayed settng s satsfactory, press the [ENTER]
key to confirm your selection.
Setting range: 0 to 9.9 (mm)
Cutout area
Registration mark pattern Mirror 1 Registration mark pattern 3
Set value
Set value
Registration mark pattern Mirror 2
Set value
Set value
Set value
Set value
Setting the Center Registration Mark
The center regstraton mark can only be read for regstraton mark pattern 3, and only when "USER" has been selected
for the regstraton mark dstance adjustment functon.
(1) When regstraton mark pattern 3 has been selected and the
[ENTER] key pressed, the menu for settng the center
regstraton mark s dsplayed.
FORCE OFFSET
SPEED QUALITY
CENTER W= --.-mm
X=----.-mm Y=---.-mm
(2) To perform plottng wth the center regstraton mark as the reference pont, press the [F1] key (CENTER) to affix the
black dot [
•
] next to CENTER and dsplay the followng menu. If you do not wsh to perform plottng wth the center
regstraton mark as the reference pont, press the [F1] key once agan to remove the black dot [
•
] and then press
the [ENTER] key .
FORCE OFFSET
SPEED QUALITY
•CENTER W= 00.0mm
X=0030.0mm Y=030.0mm
To perform plottng wth the center regstraton mark as the reference pont, press the [F2] , [F3] or [F4] key to
move the blnkng cursor to X (X-axs length), W (center regstraton mark readng poston) or Y (Y-axs length)
respectvely. Use the [ ] or [ ] key to move the blnkng cursor, the [ ] or [ ] key to change the numerc value
and the [ENTER] key to confirm your selections.
Setting range: [X/Y] 0 to 999.9 (mm), [W] -99.9 to +99.9 (mm)
a
W
b
W Y
a
b
X
Vertical line
Horizontal line
Set W in the range in which there are no vertical or horizontal lines.
(3) Press the [PAUSE] key to cancel PAUSE mode.