GRAPHTEC FC2250 Series, User Manual

Page: 23 / 130

2-4
Chapter 2 CUTTER BLADES, CUTTER PENS AND PENS
2.3 Replacing the Cutter Blade
There are four types of cutter pen. Each type has dfferent dameter blades. The blade dameter s ndcated
by the color of the blade length adjustment knob as shown n the table below. When replacng the cutter
blade, check the table below to ensure that you are usng the correct combnaton of cutter pen and cutter
blade.
Handle cutter blades with care!
Cutter pen and cutter blade combinations
Color of the
adjustment knob
Cutter pen part no.
Compatible blade types
Diameter Part no. Material
Blue PHP31-CB09-HS φ0.9 mm CB09UA
Supersteel
Red PHP31-CB15-HS φ1.5 mm
CB15U
CB15U-K30
Green PHP31-CB15B-HS φ1.5 mm
CB15U-SP
CB15U-K30-SP
Slver PHP34-CB30-HS φ3.0 mm CB30UC
Color of the blade length adjustment knob: Blue
PHP31-CB09-HS cutter pen for 0.9 mm blades
Holder (B)
(1) Remove holder (B) by turnng the blade length adjustment knob n the counterclockwse
drecton.
(2) Remove the cutter blade and sprng from the holder.
(3) Wth the holder held at an angle, nsert the new cutter blade wth ts sprng attached nto
the plunger.
(4) Make sure the cutter blade s nserted straght nto the holder. If the cutter blade s
postoned at an angle, gently tap the plunger to correct the orentaton of the cutter blade.
(5) Wth the holder facng downward, attach the holder cap and then turn the blade length
adjustment knob n the clockwse drecton untl the cutter blade tp s vsble.
(6) After a cutter blade has been replaced, check that t rotates smoothly nsde the cutter
pen.
Be careful not to stab your finger when handling the cutter blade.