GRAPHTEC FC2250 Series, User Manual

Page: 66 / 130

4-15
Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION
registration marks can be detected) but the floating up of the medium from the surface of the plotter or dirt on the
medum may cause erroneous detecton.
Make settngs for regstraton mark pattern 3, Mrror 1 and Mrror 2 n the same way.
Adjusting the Sensitivity of the Registration Mark Sensor
If you have changed the medium to a different type, we recommend that you perform this procedure.
(1) Press the [PAUSE] key to select ntl the followng menu s dsplayed.
FORCE OFFSET
SPEED QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(4) Press the [F1] key (MARK) to dsplay the regstraton mark functons selecton menu.
FORCE OFFSET
SPEED QUALITY
MODE DIST ADJ
TYPE OTHER SETUPS
(5) Press the [F4] key (OTHER SETUPS) to dsplay the menu shown below.
FORCE OFFSET
SPEED QUALITY
SIZE ADJ. SENS
ORG OFT SENS OPT
(6) Press the [F4] key (SENS OPT) to dsplay the menu shown below.
FORCE OFFSET
SPEED QUALITY
LEVEL
SENS SPD SENS STEP
(7) Press the [F1] key (LEVEL) to dsplay the menu shown below.
FORCE OFFSET
SPEED QUALITY
SENSOR ADJ TYPE 3
1,2 TYPE MIRROR
(8) Press the [F1] key (SENSOR ADJ) to dsplay the menu for adjustng the senstvty of the sensor.
FORCE OFFSET
SPEED QUALITY
SENSOR ADJUST
DEFAULT ADJUST
(9) To adjust the senstvty value, press the [F4] key (ADJUST) to dsplay the followng prompt. To select the default
value, press the [F2] key (DEFAULT).
FORCE OFFSET
SPEED QUALITY
MOVE TO ADJ. POINT
PRESS ENTER KEY!