GRAPHTEC FC2250 Series, User Manual

Page: 113 / 130

6-3
Chapter 6 TROUBLESHOOTING
The Cutting/Plotting Results are Unsatisfactory
(2/2)
Symptom Cause Solution
•
The cuttng results dffer from the
specified size.
•
When the plotter s recevng data,
the PROMPT lamp lghts. (an
offscale error occurs)
•
Some parts of the medum cannot
be cut.
The programmable resoluton (STEP SIZE)
has been set dfferently at the plotter and the
software applcaton.
Set both the plotter and software to the same
programmable resoluton.
Scaling has been specified at the computer. Check whether scaling has been specified.
The computer sent coordnate data that
exceeds the specified effective cutting area.
Set the effectve cuttng area to a larger
area.
Reduce the size of the data.
•
The currently selected cuttng
condtons cannot be stored or
changed.
The Condton Prorty settng s set to
Program.
Change the Condton Prorty settng
(Specal Functons menu) to Manual.
The [ENTER] key was not pressed after a
settng was changed.
Make sure you are settng the condtons
correctly.
•
Text or lnes are deformed durng
pen plottng.
The plotter s n Cuttng or Creasng mode. Select "PEN" for the cutter blade type n the
settng condtons.
•
The specified length is not plotted
or cut. (slght dstance error)
The dstance correcton value s not
approprate.
Specfy the approprate dstance correcton
value.
•
Text s deformed.
•
Complex mages are deformed.
The Step Pass value s too hgh. Lower the Step Pass settng.
•
The startng and end ponts do not
match.
The data s not connected. Plot the data wth a pen and then make the
correctons requred.
The Offset Cut Pressure s too low. Rase the Offset Cut Pressure settng.
The medium is too flimsy. Swtch to a stronger medum.
Cutter blade rotaton s not smooth. Remove any foregn matter adherng to the
nsde of the holder.
•
An unntentonal L-shape s cut. "2 mm BELOW" has been selected for the
Int. Blade Control poston.
Select "OUTSIDE" for the Int. Blade Control
poston. (Specal Functons menu)