![background image](http://html1.mh-extra.com/html/gmc/c-series-1993/c-series-1993_repair-manual_2235927035.webp)
SP-510 HP AIR CONDITIONING COMPRESSOR 1P6-3
Figure 2—Removing/lnstalling the Shaft Nut
Figure 3—Removing the Clutch Plate and Hub
Assembly
Important
• Do not drive or pound on the clutch bore of the
shaft. Internal damage to the compressor may
result.
2. Clutch plate and hub assembly (figure 5).
A. Install the clutch plate and hub assembly over
the compressor shaft, lining up the Key slot on
the hub with the key way slot in the shaft.
B. Place J 37826 over the shaft and tap the
assembly until it has bottomed against the
clutch shims.
NOTICE: See “Notice” on page 1D6-1.
3. Shaft nut (1).
£
Tighten
•Shaft nut (1) to 39 N-m (28 ft. lbs.). •
Inspect (Figure 6)
• Check the air gap with a feeler gage to 0.4064
to 0.7874 mm (0.016 to 0.031 inch). The air gap
is determined by the spacer shims. When rein-
Figure A— Removing/lnstalling the Shaft Key
Figure 5—Installing the Clutch Plate and Hub
Assembly
Figure 6—Measuring the Clutch Plate Gap
stalling or installing .a, new clutch assembly, try
the original shims first. When installing
a
new
clutch onto a compressor that does not have a
clutch, use 1.016 mm, 0.508 mm, or 0.127 mm
(0.040, 0.020, or 0.005 inch) shims from the
clutch accessory sack.
Summary of Contents for C Series 1993
