GMC C Series 1993, Repair Manual

Page: 261 / 264

6P5-2 DISTRIBUTORS
55. Ignition Coil Connector Terminals
56. Terminal for Distributor Module Connector
57. Terminal for Ignition Switch
and Tachometer Connector
58. Coil Lead (Secondary)
59. Four terminal Connector
:: V;-- K-,\"
\ F9374
Figure 1 —Distributor with Separate Coil
B. Drive out the roll pin with a small punch (figure
•
5. Driven gear (29), washer or .spring (31), or tang
washer (33). . ...
6 . Shaft (26) with the timer core from the housing
; (30):
7. Retainer (49) from the housing (30) as follows:
C A U T I O N : W e a r e y e p r o t e c t i o n w h e n c u t t i n g
a n d r e m o v i n g s p r i n g s t e e l r e t a i n e r c j i p s a s
d e s c r i b e d i n t h i s p r o c e d u r e . I f y o u r e y e s a r e
n o t p r o t e c t e d , f l y i n g m e t a l p i e c e s m a y c a u s e
i n j u r y .
• Round Retainer:
A. Wear safety goggles.
B. Wedge a screwdriver under the edge of the
; retainer and use a “lift and twist” motion to pry
the; edge up just far enough to get the metal
I snips onto the edge.
Cl USe; scissor-type snips to cut the retainer.
D. Use needle nose pliers to pujl the retainer off
> tljiS center bushing. Discard the retainer.
• Square Retainer:
A. Wear safety goggles.
B. USe needle nose pliers to bend two corners
upward on the fluted end of the retainer.
C. 'Ptill the retainer off the center bushing. Discard
the retainer.