![background image](http://html1.mh-extra.com/html/gmc/c-series-1993/c-series-1993_repair-manual_2235927024.webp)
1D 2-4 HR6-HE AIR CONDITIONING COMPRESSOR
4.
Remove the forcing tip on J 33013—B clutch plate and
hub assembly iiistaller-remover center screw and
reverse the body direction On the center screw, as shown
in Figure 5.
.
5.
Install the clutch plate and hub installer-remover
J 33013-B with bearing as shown in Figure 8.
The body of the J 33013-B installer-remover should be
backed off sufficiently to, allow the center screw to be
threaded onto the end of the. compressor shaft.
6.
Hold the center screw with, a wrench. Tighten the hex
portion of the installer-remover J 33013-B body to press
the hub onto the shaft. Tighten the body several turns,
remove the installer and check to see that the shaft key is
still in place in the keyway before installing the clutch
plate and hub assembly to its final position. The air gap
between frictional surfaces of the clutch plate and clutch
rotor should be 0.50-0.76mm (.020-030"):,
i, 1
' _ ‘ •
NOTICE:
If the center screw is threaded,
fully
onto
the end of the compressor: shaft, or if the body of the
installer is held and the center screw is rotated, the key
will wedge and will break the clutch hub.
7
I T ] iJ |33013-B DRIVE
[ 7 ] AIR GAP (0.20 -
—
plate
I
nstaller
0
.
30
") o.5o-o.76miti
[ T | DRIVE PLATE
H I CLUTCH PLATE
,T ^llii^TALLER BEARING .
AND HUB ASM.
' :' ! ■
■
'
’
G60090-1D2-C-R1
Fig. 5 Installing Clutch Plate & Hub Assembly
7. Renidve installer J : 33013—B, ■:.check for proper
, positioning of the shaft key (even or. slightly above the
clutch hub).
, .8. ; Spin the, pulley rotor by hand to see that the rotor is not
rubbing the clutch drive plate.
COMPRESSOR CLUTCH ROTOR AND/OR
BEARING
Remove or Disconnect
1. . Remove the clutch plate and hub assembly as described
previously.
2.
Remove rotor and bearing assembly retaining ring, using
"snap ring pliers,J 6083 (Fig. 6)..
Summary of Contents for C Series 1993
