GE LOGIQ E9, Service Manual

Page: 325 / 754

GE
D
IRECTION
5573152-100, R
EV
. 2 LOGIQ E9 S
ERVICE
M
ANUAL
Chapter 8 Replacement procedures 8 - 41
8-5-7-2 Foot Rest Bumper installation
8-5-7-3 Calibration and adjustments
No calibrations or adjustments are needed after this part replacement.
8-5-7-4 Verification
Perform the following steps to verify that the product is functioning as intended after this replacement:
1.) Connect cables and Probes you removed earlier.
2.) Power up the system to verify that it operates as intended.
8-5-7-5 Functional Checks
Perform the following functional checks to confirm the system is operational before returning the system
to the customer.
If all are successful, include the following debrief script: LOGIQ E9 Service Manual, Direction
5573152-100, Rev. 2. Equipment passed all required checks and is ready for use.
Table 8-23 Foot Rest Bumper installation
Steps
Corresponding Graphic
1. Position the Foot Rest Bumper in place.
Push the Foot Rest Bumper down and over the pedals.
You may need to push down the pedals to be able to place the Foot Rest Bumper.
2. Replace the Side Covers, if they were removed.
Table 8-24 Foot Rest Bumper replacement Functional Checks
See:
Section Functional Check Debrief Script
4-2-2 Power ON/Boot Up
LOGIQ E9 Service Manual, Direction
5573152-100, Rev. 2. Equipment passed all
required checks and is ready for use.
4-2-3 Power shut down
4-3-13 Probe/Connectors Checks
4-3-5 B-Mode Checks
4-3-7 System CFM and PWD Checks
4-3-17 Mechanical Function Checks
4-3-17-2 Brakes and Direction Lock Checks