GE Dash 3000, Service Manual

Page: 123 / 292

Revision A Dash 3000/4000 Patient Monitor 5-7
2000966-339
Troubleshooting: Service Menus
MENU SETUP This menu selection provides the following sub-
menus: (Refer to Chapter 6,
“Configuration” for
detailed procedures.)
„
ADMIT MENU: STANDARD
This menu selection allows you to determine the
function of the patient monitor. The four variables
include stationary or ambulatory (telemetry) patient
monitoring with a monitor that always stays in one
room (STANDARD) or a monitor that moves from
room to room (
ROVER ).
„
MONITOR DEFAULTS PASSWD
This menu selection allows you to set the monitor
so that a password is Required or Not Required for
entry into the Monitor Defaults menu section. If
selected, the password will be the same as the
Service Mode Menu password.
MONITOR SETTINGS This menu selection provides the following sub-
menus: (Refer to Chapter 6,
“Configuration” for
detailed procedures.)
„
SET UNIT NAME
This menu selection allows changes to the care
unit name. After initial setup, this name should not
be changed or communication to the central
station will be corrupted. Note that the care unit
name must be registered exactly the same in the
central station and the patient monitor.
„
SET BED NUMBER
This menu selection allows changes to the bed
number. After initial setup, this number should not
be changed or communication to the central
station will be corrupted. Note that the bed number
must be registered exactly the same in the central
station and the patient monitor.
„
SET INTERNET ADDRESS
This menu selection allows changes to the internet
(IP) address. An incorrect internet address may
also prevent the monitor from viewing other
monitors on the network even though the unit
names match. Whether or not this can occur
depends on the network topology at the installed
site.
Service Mode Menu Options (Continued)
Menu Option Description