GE Corometrics 126, Service Manual

Page: 157 / 440

Revision B 120 Series Maternal/Fetal Monitor 5-13
2015590-001
Setup Procedures: MSpO2 Setup Screen
MSpO
2
Setup Screen
Select the
MSPO2
softkey to display the MSpO
2
Setup screen ( Figure 5-4 ). For
settings information, refer to Appendix A, “Factory Defaults” .
Figure 5-4. Nellcor MSpO
2
Setup Screen
NOTE:
If you are using Masimo (instead of Nellcor) technology, the Response
Time setting will be missing on your Setup Screen. In its place, a setting
for Averaging Time and Sensitivity will display.
Response Time (Nellcor Module Only)
Choose a response time modes in order to compensate for different levels of patient
activity.
„
Slow: Uses a 10- to 15-second averaging period and is least affected by patient
movement. When this setting is selected, dashes “– – –” replace the pulse value
displayed in the MHR/P area.
„ Normal: Uses a 5- to 7-second averaging period and is recommended in cases
where the patient is relatively inactive.
„
Fast: Uses a 2- to 3-second averaging period and is most affected by patient
movement.
Sensitivity (Masimo Module Only)
This menu option appears only when using a Masimo module and sensor.
„
Normal: Use the Normal sensitivity setting for normal patient monitoring
purposes.
„ Maximum: Use the Maximum sensitivity setting for improved low perfusion
performance and for faster tracking of rapid MSp02 saturation changes.
165 172 30
97%
MSpO
2
EXIT
US FECG TOCO
ALARM HIGH LOW
MSpO
2
: 100 95 %
MHR/P: 120 50 BPM
AUDIO ALARMS: ON VOLUME: 5
RESPONSE TIME: NORMAL
PRINT INTERVAL: 5 MIN
% O2 TRACE: OFF
MSpO
2
SETUP