Extreme Networks ExtremeWare XOS 11.0, Command Reference Manual

Page: 331 / 970

configure sflow collector ipaddress
ExtremeWare XOS 11.0 Command Reference Guide 331
configure sflow collector ipaddress
configure sflow collector {ipaddress} <ip-address> {port <udp-port-number>}
{vr <vrname>}
Description
Configures the sFlow agent’s IP address.
Syntax Description
Default
The following values are the defaults for this command:
• UDP port number—6343
• Virtual router—VR-Mgmt (previously called VR-0).
Usage Guidelines
This command allows you to configure where to send the sFlow data. You must specify an IP address
for the sFlow data collector, and you may specify a particular UDP port, if your collector uses a
non-standard port. You may also need to specify from which virtual router to send the data.
You can configure up to four sFlow collectors. Each unique IP address/UDP port combination identifies
a collector.
Both the commands
unconfigure sflow
and
unconfigure sflow collector
will reset the collector
parameters to the default.
Example
The following command specifies that sFlow data should be sent to port 6343 at IP address 192.168.57.1
using the virtual router
VR-Mgmt :
configure sflow collector ipaddress 192.168.57.1
History
This command was first available in ExtremeWare XOS 11.0.
ip-address Specifies the IP address to send the sFlow data.
udp-port-number Specifies the UDP port to send the sFlow data.
vrname Specifies from which virtual router to send the sFlow data.