Extreme Networks ExtremeWare XOS 11.0, Command Reference Manual

Page: 502 / 970

502 ExtremeWare XOS 11.0 Command Reference Guide
STP Commands
configure stpd forwarddelay
configure stpd <stpd_name> forwarddelay <seconds>
Description
Specifies the time (in seconds) that the ports in this STPD spend in the listening and learning states
when the switch is the Root Bridge.
Syntax Description
Default
15 seconds.
Usage Guidelines
If your STPD has the same name as another component, for example a VLAN, Extreme Networks
recommends that you specify the identifying keyword as well as the name. If your STPD has a name
unique only to that STPD, the keyword
stpd
is optional.
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
The range for the
<seconds>
parameter is 4 through 30 seconds.
Example
The following command sets the forward delay from STPD1 to 20 seconds:
configure stpd stpd1 forwarddelay 20
History
This command was available in ExtremeWare XOS 10.1.
stpd_name Specifies an STPD name on the switch.
seconds Specifies the forward delay time in seconds. The range is 4 to 30 seconds.