Extreme Networks ExtremeWare XOS 11.0, Command Reference Manual

Page: 893 / 970

configure pim add vlan
ExtremeWare XOS 11.0 Command Reference Guide 893
configure pim add vlan
configure pim add vlan [<vlan_name> | all] {dense | sparse}
Description
Enables PIM on an IP interface.
Syntax Description
Default
Dense.
Usage Guidelines
When an IP interface is created, per-interface PIM configuration is disabled by default.
The switch supports both dense mode and sparse mode operation. You can configure dense mode or
sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense mode, while
others run sparse mode.
Example
The following command enables PIM-DM multicast routing on VLAN accounting :
configure pim add vlan accounting dense
History
This command was available in ExtremeWare XOS 10.1.
vlan_name Specifies a VLAN name.
all Specifies all VLANs.
dense Specifies PIM dense mode (PIM-DM).
sparse Specifies PIM sparse mode (PIM-SM).