Extreme Networks ExtremeWare XOS 11.0, Command Reference Manual

Page: 326 / 970

326 ExtremeWare XOS 11.0 Command Reference Guide
Commands for Status Monitoring and Statistics
configure log target match
configure log target [console | memory-buffer | nvram | primary-msm |
backup-msm | session | syslog [all | <ipaddress> {vr <vr_name>} [local0 ...
local7]]] match [any |<match-expression>]
Description
Associates a match expression to a target.
Syntax Description
Default
By default, targets do not have a match expression. If a virtual router is not specified, VR-Mgmt is used.
Usage Guidelines
This command configures the specified target with a match expression. The filter associated with the
target is not affected. A message is sent to a target if the target has been enabled, the message passes the
associated filter, the message is at least as severe as the configured severity level, and the message
output matches the regular expression specified.
See the command
show log
on page 364 for a detailed description of simple regular expressions. By
default, targets do not have a match expression.
Specifying
any
instead of
match-expression
effectively removes a match expression that had been
previously configured, causing any message to be sent that has satisfied all of the other requirements.
To see the configuration of a target, use the following command:
show log configuration target {console | memory-buffer | nvram | primary-msm |
backup-msm | session | syslog <ipaddress> [local0 ... local7]}
console Specifies the console display.
memory-buffer Specifies the switch memory buffer.
nvram Specifies the switch NVRAM.
primary-msm Specifies the primary MSM.
backup-msm Specifies the backup MSM.
session Specifies the current session (including console display).
syslog Specifies a syslog target.
all Specifies all of the remote syslog servers.
ipaddress Specifies the syslog IP address.
vr_name Specifies the virtual router that can reach the server IP address.
local0 ... local7 Specifies the local syslog facility.
any Specifies that any messages will match. This effectively removes a previously
configured match expression.
match-expression Specifies a regular expression. Only messages that match the regular
expression will be sent.